Basic Part No. O.D. A  Bolt Crcle B  Rod Dia. C  Boss Thd. D  Boss Lngth E  Thd. F  Wr. Flats G  Lngth H  Depth J  Off- set K Ream L Width M Width N Piston (IN) Piston Area (Sq.In)  Nom. Force (lbs) = Pressure (psi) times Area (sq. in.) Table 1 Part No. E NOTES: Dimensions are nominal in U.S. Customary units. Metric versions are dimensionally equivalent except for conversion in mounting details where fasteners, threads, clearance holes & counter-bores are to metric standards. To see a table of U.S. Customary to Metric fastener conversion, click here . There is no added cost for this metric modification. An air/oil mist unit is recommended for internal lubrication. Where such units are not practical, SERVICE KITS including seals and factory approved lube are available. Cylinders may also be used in low pressure hydraulic service. Wrench flats may not be necessary if cylinders can be pressurized in the retracted or extended position while tightening the rod joint. Inquiries regarding modification to BASIC CYLINDERS are always welcome.

---

Index Page

Mack Corp. Home

Next Page

Wall Chart

Click robot for printer friendly page.

---

To request a quote for a unit on this page, please fill out the following form and submit.

REQUIRED ENTRIES

1) Please enter the BASIC PART NO:

2)PISTON TRAVEL
US Standard Click Here 1 (0.100) 2 (0.200) 3 (0.300) 4 (0.400) 5 (0.500) 6 (0.600) 7 (0.700) 8 (0.800) 9 (0.900) 10 (1.000) (shown in 1/10 inch increments, maximum 1.000 in.)
Metric Click Here 2.5mm 5.0mm 7.5mm 10.0mm 12.5mm 15.0mm 17.5mm 20.0mm 22.5mm 25.0mm (shown in 2.5mm increments, maximum 25.0mm.)

OPTIONAL ENTRIES

3) MOUNTING STYLE:
Default CBB -Thru clearance holes with c'bores in the body for no. 4-40 I.S.H.C.S. at 4 locations. FL - This cover is larger for flange mounting to either side. T - Mounting directly to the user's structure provides the lowest overall height. TC - Alternate mounting to user's structure to provide minimum overall height.

Default Click here for extra info.

CBB -C'bore in the body. Click here for extra info.

FL - Flange mounting. Click here for extra info.

T - Mntng to user's structure. Click here for extra info.

TC -Mntng to user's structure. Click here for extra info.

4)ROD ENDS: Default (spherical radius) ITW - Internal Threads with Wrench Flats ETW - External Threads with Wrench Flats SR - Slotted rod ends RL - Rod end with lug

ITW - Internal Threads with Wrench Flats

ETW - External Threads with Wrench Flats

SR - Slotted Rod End

RL - Rod End with Lug

5)PORTS: Default (1/16 NPT Port) 10-32 (USA 10-32 threaded ports. Straight thread. Flat gasket sealing.)

6) O-Ring Option:

Default (Buna "N" O-rings, -40ºF. To +250ºF.)
Viton "O"rings (-15ºF. To +400º F.)

7) Quantity:

8) Customer Information

Name
Title
Company
Address
City
State/Province
Country
Zip Code
Telephone

Fax
Email

Comments